Thermo RamseyTILT SWITCH LEVEL INDICATORThe Thermo Ramsey Tilt Switch Control System consists of one Tilt Switch Probe and one Tilt Switch Control, that contains a time delay, an amplifier and an output relay.PROBESContact Tilt Switch Probe - It consists of a probe sensitive to the tilt with regard to its normal vertical position.Applications :The strong and simple structure allows a high safety operation and installation ease. The principal use conditions are :High level signal for silos and hoppers. High level signal for stockpilings. Blocking in the charge/discharge areas of the conveyor belts. Signal of material presence of lacking on the belt. In other applications where the effect is the tilt of the probe. Accessories :Two accessories are foreseen to apply to the probe :Stainless steel finning to extend the supporting surface with very light material. Rubber blade for extension or anti-abrasion. Resistor Tilt Switch Probe - It is a probe sensitive to the conductive resistance of the material.Applications :It is used for high and low level signals.The measure principle is on the resistance change, caused by the presence or absence of material between the probe and the inner silo surface.TILT SWITCH CONTROL UNITThe Control Unit is made up of an electronic board that includes and amplifier, a time delay circuit and a circuit to permit the output of a relay. it can be used for outdoor installation, in a watertight enclosure with two lamps: one for normal operation and one for alarm in the front cover.